Skip to main content



      Home
Home » Archived » IAM (Eclipse Integration for Apache Maven) » Mvn classpath container empty after pom change
Mvn classpath container empty after pom change [message #571292] Thu, 12 November 2009 12:31 Go to next message
Eclipse UserFriend
Every now and then when i make a change to the pom of a WTP project the maven classpath container becomes empy. There are no error messages and mvn compile on the command line works fine. The only way to get the classpath back again is to

1 Disable and enable maven on the project
2 Close and open the project

Often we have to repeat this a couple of times before everything pops back to normal again. IAM works perfectly except for this little annoying detail. Any suggestions?

Ganymede IAM 0.10
Re: Mvn classpath container empty after pom change [message #571303 is a reply to message #571292] Thu, 12 November 2009 15:57 Go to previous message
Eclipse UserFriend
are there any error messages in the Error Log view?

On 11/12/09 9:31 AM, danielh wrote:
> Every now and then when i make a change to the pom of a WTP project the
> maven classpath container becomes empy. There are no error messages and
> mvn compile on the command line works fine. The only way to get the
> classpath back again is to
>
> 1 Disable and enable maven on the project
> 2 Close and open the project
>
> Often we have to repeat this a couple of times before everything pops
> back to normal again. IAM works perfectly except for this little
> annoying detail. Any suggestions?
>
> Ganymede IAM 0.10
Previous Topic:Picking up wrong version of dependency if dependent project open
Next Topic:Mvn classpath container empty after pom change
Goto Forum:
  


Current Time: Wed Jul 16 13:06:30 EDT 2025

Powered by FUDForum. Page generated in 0.06245 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top