|
Re: Debug Process output in console [message #498698 is a reply to message #498686] |
Wed, 18 November 2009 08:35 |
Alex Panchenko Messages: 342 Registered: July 2009 |
Senior Member |
|
|
Hi Sheela,
Why do you want to ignore process output? Why is it printed, if nobody
wants it?
The reason why it was added is that if launched process dies before
establishing DBGP connection the only way to show details is print it
into stdout/stderr. So, I think it's quite useful feature.
The "Debug Console Redirection" option is used to turn on DBGP streams
redirection, i.e. send "stdout 2" and "stderr 2" commands, so launched
process should start sending output over DBGP. Without it the process
just sends output directly to stdout/stderr.
Regards,
Alex
Sheela wrote:
> Hi,
> We have migrated our IDE from Dltk R1.0 to S2.0M3.
>
> In DLTK R1.0 version of our IDE, when we debug the script locally,the
> console shows only the output received as a part of DBGP response.
>
> But in DLTK S2.0M3 version of our IDE,we have observed that while local
> debugging the console shows the output received as a part of DBGP
> response as well as the output of the process.
>
> Is there any handle,so that we could turn off the output from the
> process and the console shows only the output received as a part of DBGP
> response ?
>
> Also,in Debug Launch Configuration Tab,there is a new option "Debug
> Console Redirection".What is the purpose of this option ? Is this option
> related to our issue ?
>
>
> regards,
> sheela
|
|
|
|
Powered by
FUDForum. Page generated in 0.02789 seconds