|
Re: How to make a Class and an Interface read-only? [message #477615 is a reply to message #477614] |
Thu, 17 July 2008 11:43 |
Ed Merks Messages: 33218 Registered: July 2009 |
Senior Member |
|
|
Tom,
Please avoid cross posting the same question as separate postings to
multiple newsgroups. This is being answered in the GMF newsgroup...
Tom wrote:
> Is it possible to make a Class and an Interface read-only, ie. to
> finalize it so that no further modifications, such as adding new
> attributes or making connections from it, could be done? If not, what
> modifications of the GMF (or/and EMF,GEF) should I perform to get this
> function?
>
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Re: How to make a Class and an Interface read-only? [message #626805 is a reply to message #477614] |
Thu, 17 July 2008 11:43 |
Ed Merks Messages: 33218 Registered: July 2009 |
Senior Member |
|
|
Tom,
Please avoid cross posting the same question as separate postings to
multiple newsgroups. This is being answered in the GMF newsgroup...
Tom wrote:
> Is it possible to make a Class and an Interface read-only, ie. to
> finalize it so that no further modifications, such as adding new
> attributes or making connections from it, could be done? If not, what
> modifications of the GMF (or/and EMF,GEF) should I perform to get this
> function?
>
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Powered by
FUDForum. Page generated in 0.04032 seconds