|
Re: EMF and CNF [message #427608 is a reply to message #427597] |
Tue, 24 February 2009 09:55 |
Ed Merks Messages: 33218 Registered: July 2009 |
Senior Member |
|
|
I think the GMF folks have bugzillas open to explore this but I have no
direct experience. I'm not sure how things like save are supported in
such a context. To get undo/redo support you'd have to use commands
along with an AdapterFactoryEditingDomain just like the one that's set
up in the generated editor...
exquisitus wrote:
> Hi All,
>
> I am looking forward to tie EMF and CNF - Common Navigator Framework.
> Is there any way to edit models using CNF ? I can't find any helpful
> documents / examples addressing this issue on the web. Actually, I can
> apply basic CRUD operations on my models using popup menus but without
> undo/redo support.
>
> thx for the help.
>
> Cheers.
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Powered by
FUDForum. Page generated in 0.04516 seconds