Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Newcomers » Newcomers » Generate .temp-runconfig-classpath-arg.txt file via command line(Generate .temp-runconfig-classpath-arg.txt file via command line)
Generate .temp-runconfig-classpath-arg.txt file via command line [message #1854719] Sat, 03 September 2022 16:49 Go to next message
Adithi Krishnan is currently offline Adithi KrishnanFriend
Messages: 1
Registered: September 2022
Junior Member
Hi Everyone,

I am a newcomer here and not sure if this has been asked and answered before. I have setup a gradle project in Eclipse which uses Selenium-Java for UI automation testing. It is based on Cucumber framework and am using TestNG to run my testcases. I have created a run configuration in Eclipse for the above suite and it runs fine. I want to run the suite from cmd line for which if I click on 'Show command line' in Run Configurations menu, it gives me the exact command. My only doubt is is there anyway we can generate the .temp-runconfig-classpath-arg.txt file via cmd line rather than going to Eclipse and copying the command line everytime which generates a new .temp file evey time

Re: Generate .temp-runconfig-classpath-arg.txt file via command line [message #1854748 is a reply to message #1854719] Wed, 07 September 2022 09:51 Go to previous message
cristelle AMELDA is currently offline cristelle AMELDAFriend
Messages: 6
Registered: August 2022
Junior Member
Hello I would like to know too
Previous Topic:Configure Network Proxy Error
Next Topic:Unable to open
Goto Forum:

Current Time: Wed Feb 08 14:54:36 GMT 2023

Powered by FUDForum. Page generated in 0.02532 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top