Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » Sirius » Creating visual models other than component-connector style
Creating visual models other than component-connector style [message #1808324] Fri, 21 June 2019 14:07 Go to next message
Arunkumar Ramaswamy is currently offline Arunkumar RamaswamyFriend
Messages: 57
Registered: April 2014
Member
Hello

All the diagrams created in Sirius is in a kind of component-connector style. Is it feasible to create a tool using Sirius that can create models as shown below. For example, I drag the intersection of the road and then the vehicles, pedestrian, road signs etc.

index.php/fa/35789/0/

Any help much appreciated.

Regards
Arun
  • Attachment: scenario.png
    (Size: 17.61KB, Downloaded 181 times)
Re: Creating visual models other than component-connector style [message #1808330 is a reply to message #1808324] Fri, 21 June 2019 14:52 Go to previous messageGo to next message
Pierre Guilet is currently offline Pierre GuiletFriend
Messages: 250
Registered: June 2017
Senior Member
Hi Arun,

Your use case seems standard to me except for edges.
You have edges without nodes attached to the end. This can be achieved with Sirius by defining a transparent node https://www.eclipse.org/forums/index.php/m/1792206/?srch=edge+invisible#msg_1792206.
You have an edge with a curve. This cannot be done with Sirius. Though you have the manhattan style that will be orthogonal.
Otherwise road, cards, pedestrian will just be basic node with workspace image.

Regards.


Pierre Guilet - Obeo
Need training or professional services for Sirius?
http://www.obeodesigner.com/sirius
Re: Creating visual models other than component-connector style [message #1808484 is a reply to message #1808330] Tue, 25 June 2019 14:12 Go to previous messageGo to next message
Arunkumar Ramaswamy is currently offline Arunkumar RamaswamyFriend
Messages: 57
Registered: April 2014
Member
Thank you for your answer. Is it possible to restrict the placement of certain elements with respect to other elements. For example, the car should be snapped to center of lane etc.

Thanks in advance
Re: Creating visual models other than component-connector style [message #1808517 is a reply to message #1808484] Wed, 26 June 2019 08:24 Go to previous message
Pierre Guilet is currently offline Pierre GuiletFriend
Messages: 250
Registered: June 2017
Senior Member
Hi,

Sirius has a snap grid available where you can configure the grid spacing. If the grid fits correctly all the lanes then you will be able to snap vehicules in the middle.
To activate it select the background of the diagram and click on Rulers and grid tab in properties view. This would require to adapt the road image so any lane fit the grid.
Another solution would be to determine all points of lanes and to provide a custom arrange all where all vehicules placed manually are put to the nearest lane point of their actual approximated position.
I don't see other solutions.

Regards,


Pierre Guilet - Obeo
Need training or professional services for Sirius?
http://www.obeodesigner.com/sirius
Previous Topic:Opening sirius session
Next Topic:Viewpoint Selection - no viewpoint available
Goto Forum:
  


Current Time: Tue Oct 15 21:31:10 GMT 2019

Powered by FUDForum. Page generated in 0.02748 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top