Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » Kura » Run kura from command line without using UI(Kura framework)
Run kura from command line without using UI [message #1803603] Tue, 05 March 2019 10:15 Go to next message
Rishik singh is currently offline Rishik singhFriend
Messages: 2
Registered: March 2019
Junior Member
After installaing kura on raspberry pi, we can start kura as service. But then we need to open localhost and manually enter kapua details to connect and publish data.
Can we run Kura as service and then with out using GUI, it gets connection establish and sends the data to kapua.
I would like to do everything from command line.
Re: Run kura from command line without using UI [message #1803954 is a reply to message #1803603] Thu, 14 March 2019 09:09 Go to previous message
Matteo Maiero is currently offline Matteo MaieroFriend
Messages: 393
Registered: July 2015
Location: Italy
Senior Member
Hi,
I believe you can use the OSGi console.
But, in my opinion, it is a little bit limiting and probably something needs to be developed.
What I can suggest, if you just need to connect to Kapua is to change the snapshot setting the desired configuration.

Best regards,
Matteo
Previous Topic:Kura replace MQTT with CoAP
Next Topic:java.lang.NoClassDefFoundError: javafx/collections/MapChangeListener
Goto Forum:
  


Current Time: Mon Jul 06 21:12:25 GMT 2020

Powered by FUDForum. Page generated in 0.06781 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top