Stepping through code in Photon is slow, but clicking on trace speeds it up [message #1793677] |
Mon, 13 August 2018 23:27 |
David M. Karr Messages: 802 Registered: July 2009 |
Senior Member |
|
|
After upgrading to Photon, I've been noticing that stepping through code is seemingly much slower than it used to be. I particularly notice when I do a "Step Over" on a simple line of code. It takes several seconds before the green highlight appears on the next line.
What I discovered, however, is that after doing "Step Over", if I then just click on the stacktrace, at the top of the stack, it immediately updates the green highlight in the code. I can step through the code quite a bit faster by pressing F6 (step over), then immediately clicking on the stack entry, and then F6, and so on.
This is is a workaround, but it's still an annoyance.
There's nothing significant in the error log.
Is this enough information for a bug report?
|
|
|
|
Powered by
FUDForum. Page generated in 0.03269 seconds