Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » 4DIAC - Framework for Distributed Industrial Automation and Control » question for the port set of FORTE
question for the port set of FORTE [message #1773516] Thu, 28 September 2017 18:14 Go to next message
Fei  Yin is currently offline Fei YinFriend
Messages: 36
Registered: July 2017
for this sentence in the dokument for the opc ua protocol "To start two FORTE instances on the same PC, you can pass the port on the command line, e.g., ./forte -c localhost:61500" i don't know how can i set the port for FORTE. It says that i kann pass the port on the command line. But where can i give the command line? what is the definite command? Are you so kind to tell me?

Thank you in advance
Fei Yin
Re: question for the port set of FORTE [message #1773566 is a reply to message #1773516] Fri, 29 September 2017 13:13 Go to previous message
Martin Melik-Merkumians is currently offline Martin Melik-MerkumiansFriend
Messages: 104
Registered: March 2016
Senior Member
Command line - like terminal, command shell, shell, power shell, you know like the stuff where you put in your written commands

Previous Topic:question for the port set of FORTE
Next Topic:a question to the opc ua client in 4diac
Goto Forum:

Current Time: Thu Jun 24 20:04:31 GMT 2021

Powered by FUDForum. Page generated in 0.01908 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top