Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » 4DIAC - Framework for Distributed Industrial Automation and Control » question for the port set of FORTE
question for the port set of FORTE [message #1773514] Thu, 28 September 2017 18:14
Fei  Yin is currently offline Fei YinFriend
Messages: 36
Registered: July 2017
Member
for this sentence in the dokument for the opc ua protocol "To start two FORTE instances on the same PC, you can pass the port on the command line, e.g., ./forte -c localhost:61500" i don't know how can i set the port for FORTE. It says that i kann pass the port on the command line. But where can i give the command line? what is the definite command? Are you so kind to tell me?

Thank you in advance
Fei Yin
Previous Topic:Current state of Modbus support
Next Topic:question for the port set of FORTE
Goto Forum:
  


Current Time: Mon Oct 15 22:18:59 GMT 2018

Powered by FUDForum. Page generated in 0.01939 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top