|Eclipse CDT "hello world" after "New ... Finish" [message #1773495]
||Thu, 28 September 2017 15:33
| Vaclav Sal
Registered: September 2014
There are plenty of tutorials about how to implement "hello world" in Eclipse CDT. |
I am looking for a guide after "Finish" of "New → C program..." .
Is there such guide ?
For example - after "finish" the base C file is displayed - where is that documented?
For debugging purposes the compiler should be optioned with "verbose" at the start of the development. But one has to guess / experiment to find that out - not everybody is an expert.
I am basically frustrated with so many "automated / hidden steps" of Eclipse CDT which are so difficult to reliably reproduce with same results.
Powered by FUDForum
. Page generated in 0.01908 seconds