|Node positioning problem [message #1770644]
||Tue, 15 August 2017 14:13
|| Ran Wei
Registered: September 2012
Location: York, UK
I have unfortunately another question to ask with regard to dialog and nodes.
I have a node creation with open dialog, in which I first create a node and then bring a dialog to ask for input for the attributes input for the node.
The problem is, if I do not enter any thing in the dialog and hit "ok", the node is created where I click-and-drop the node creation icon.
But if I fill in attribute details in the dialog, the node is created and put to (0,0) in the diagram, not where I click-and-drop the node creation icon.
Could you please advise what would be the possible cause of this?
Department of Computer Science
University of York
Powered by FUDForum
. Page generated in 0.01902 seconds