|
Re: Keep tool selection [message #1708428 is a reply to message #1708426] |
Wed, 16 September 2015 12:35 |
|
Hi Martin,
Le 16/09/2015 14:14, Martin Schreiber a écrit :
> The "Select" tool is selected after using any other tool. If I do have
> multiple tools and the user chooses one (e.g. Edge creation tool) and
> uses it by creating a connection between to edges, the "Select" tool is
> selected after using it. So creating more than one connection without
> re-seleting the "Connection" tool is not possible.
As documented in [1]: if you want to apply the same tool several times
in a row, simply hold the Ctrl key pressed while using it; it will stay
«armed» until you release the Ctrl key or select another tool.
This also works for Edge creation tools.
Note that on Mac OS, you have to use Cmd and not Ctrl.
> Is there a way to specify it in the Specification Editor that the tool
> selection is kept?
The keybord shortcut is here for all tools in the palette of any Sirius
designers, there is no corresponding parameter in the specification model.
>
> Thanks!
Regards
--
Maxime - Obeo
Need training or professional services for Sirius?
http://www.obeodesigner.com/sirius
--
[1]
https://www.eclipse.org/sirius/doc/user/diagrams/Diagrams.html#UsingTheToolsFromThePalette
Maxime Porhel - Obeo
Need training or professional services for Sirius?
http://www.obeodesigner.com/sirius
|
|
|
Powered by
FUDForum. Page generated in 0.02822 seconds