|How can I check wether a Figure is selected or not? [message #720954]
||Wed, 31 August 2011 10:39
| Joern Dreyer
Registered: June 2011
Location: Kassel, Germany
After writing an Identifier for our class diagram elements I would like to check that an alement selected in the model tree is also selected in the diagram when the two are linked. I can happyly select a class (figure) via textpath ond check that the corresponding node is selected, too. Selecting a node in the tree works, but then I cannot find a way to check the class (figure) has also been selected.|
There is no ub_fcv_checkFigureHasFocus or ub_fcv_checkFigureisSelected and using ub_fcv_checkFigureProperty with property "focus" or "selected" and matching it with true was a long shot and does not work, anyway.
So, can I somehow check the selection of a figure with Jubula?
How do I find out what kind of properties are available with ub_fcv_checkFigureProperty?
There is an example: For "width" and "height" properties, enter the value in pixels. How do I match boolean values? "true"/"false" and what value operator is useful for that? I would assume equals was enough?
Thx a lot!
[Updated on: Wed, 31 August 2011 10:40]
Report message to a moderator
Powered by FUDForum
. Page generated in 0.01902 seconds