Eclipse Community Forums: Newcomers » Eclipse crash recovery

Help

Home

Home » Newcomers » Newcomers » Eclipse crash recovery(Recover dependency data from previous workspace)

Show: Today's Messages :: Show Polls :: Message Navigator

Eclipse crash recovery [message #1053633]

Tue, 07 May 2013 01:11

Shivasankari Kannan

Messages: 2
Registered: May 2013

Junior Member

I am using Eclipse helios in Ubuntu OS. It crashed and did not start up again. The .metadata/.log file had the following error: "An error occurred while automatically activating bundle org.eclipse.core.resources (65)" followed by a lot of exceptions.

The common solution suggested for the above error was to delete .snap file in .metadata/.plugins/org.eclipse.core.resources/.snap. That worked for restarting eclipse, but the project data was lost. Since I did not setup the project dependencies, I am clueless to set it up again. Is there any way to do that from the existing metadata. Thanks in advance for any help!!

Report message to a moderator

Re: Eclipse crash recovery [message #1053760 is a reply to message #1053633]

Tue, 07 May 2013 13:56

Ed Merks

Messages: 33141
Registered: July 2009

Senior Member

If your projects are all still in some workspace somewhere you can
always import existing projects from the file system (the folder where
you have the workspace) into a new workspace.

On 07/05/2013 3:06 PM, Shivasankari Kannan wrote:
> I am using Eclipse helios in Ubuntu OS. It crashed and did not start
> up again. The .metadata/.log file had the following error: "An error
> occurred while automatically activating bundle
> org.eclipse.core.resources (65)" followed by a lot of exceptions.
> The common solution suggested for the above error was to delete .snap
> file in .metadata/.plugins/org.eclipse.core.resources/.snap. That
> worked for restarting eclipse, but the project data was lost. Since I
> did not setup the project dependencies, I am clueless to set it up
> again. Is there any way to do that from the existing metadata. Thanks
> in advance for any help!!

Ed Merks
Professional Support: https://www.macromodeling.com/

Report message to a moderator