| AGR: Set Breakpoint [message #137303] |
Wed, 22 October 2008 14:35  |
Eclipse User |
|
|
|
Eclipse SDK: 3.3.2
TPTP: 4.4.1
I am trying to set a breakpoint using automated GUI recording, but so far
I have unsuccessful.
Ways I have tried (mouse position recording off):
1. Open file in editor, double-click on specific line number
2. Open file in editor, right-click on specific line number and select
Toggle Breakpoint
The first cases fails because no double-click detection, and even when I
am able to get focus on the editor, it cant find a line number. Which
brings me to case 2, it fails stating it cant run the Toggle Breakpoint
command. So I think I am stuck...
Any suggestions?
Mark
|
|
|
| Re: AGR: Set Breakpoint [message #137315 is a reply to message #137303] |
Wed, 22 October 2008 14:54  |
| Eclipse User |
|
|
|
Found a solution:
1. Open file in editor
2. From Navigate menu, choose Go to Line
a. Enter line number
3. From Run Menu, select Toggle Breakpoint or Toggle Line Breakpoint
Its not exactly how a user would 'normally' do it, but it works!
|
|
|
Powered by
FUDForum. Page generated in 0.03629 seconds
Home