Eclipse Community Forums: C / C++ IDE (CDT) » After "Build Complete", process takes 3 seconds to finish

Home » Language IDEs » C / C++ IDE (CDT) » After "Build Complete", process takes 3 seconds to finish

After "Build Complete", process takes 3 seconds to finish [message #917022]

Wed, 19 September 2012 14:40

Eclipse User

When I build my c++ module, the "Build Complete" notification shows up but it still takes a few seconds for the process to go away. I often look at the console output and fix compile errors before the build finishes and I can't rebuild until this is done (saving and running certain external tools also block) so it is a bit annoying. What is eclipse doing in this time and can I disable it?

Re: After "Build Complete", process takes 3 seconds to finish [message #917166 is a reply to message #917022]

Wed, 19 September 2012 17:55

Eclipse User

Most likely eclipse is busy refreshing the project (searching for new files and files modified by build). If it is big it could take noticeable time. You can define refresh policy in project properties->C/C++ Build->[Refresh Policy] tab.

Andrew

Re: After "Build Complete", process takes 3 seconds to finish [message #918040 is a reply to message #917166]

Thu, 20 September 2012 13:26

Eclipse User

It works! I've reduced the time now to under a second. Too bad it is a blocking operation though. Thanks for your help.

Previous Topic:	Eclipse and FFTW
Next Topic:	Managed Build Associate ProjectType with Existing General Category

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Jul 25 16:02:15 EDT 2025

.:: Contact :: Home ::.

Breadcrumbs

Sign up to our Newsletter