Eclipse Community Forums: Papyrus » Horizontal Instead of Vertically Oriented Regions for States in State Machine Diagrams

Home » Modeling » Papyrus » Horizontal Instead of Vertically Oriented Regions for States in State Machine Diagrams

Horizontal Instead of Vertically Oriented Regions for States in State Machine Diagrams [message #902240]

Thu, 16 August 2012 09:48

Eclipse User

Hi there,

When I add an additional region to a state in a State Machine Diagram (Papyrus 0.9.0/Juno), the regions are shown vertically oriented (i.e. side-by-side); is there any way to change this so that the regions are horizontally oriented (i.e. top-to-bottom)

Thanks

Alex.

[Updated on: Thu, 16 August 2012 09:49] by Moderator

Re: Horizontal Instead of Vertically Oriented Regions for States in State Machine Diagrams [message #902258 is a reply to message #902240]

Thu, 16 August 2012 11:21

Eclipse User

I just tried the same task in Papyrus 0.8.2/Indigo, and it allows me to choose the orientation of my regions (horizontal/vertical) before I click to create it.

So is this a bug in 0.9.0, or has this feature been deliberately removed for some reason?

Thanks

Re: Horizontal Instead of Vertically Oriented Regions for States in State Machine Diagrams [message #1053294 is a reply to message #902240]

Fri, 03 May 2013 11:57

Eclipse User

I am using 0.10 and can find no way to orient a region horizontally. I can only do vertical regions. What's the solution to this? Where do I go to customize its appearance? I looked exhaustively; can't find any option yet.

Re: Horizontal Instead of Vertically Oriented Regions for States in State Machine Diagrams [message #1053530 is a reply to message #902240]

Mon, 06 May 2013 08:11

Eclipse User

Hi,

It depends on where you click to create a new Region. On the top or bottom of your StateMachine, it will create an Horizontal Region. On the left or right, it will create a Vertical region. The feedback shows the orientation of the Region before you create it.

There were a bug on this feature (Feedback display) in the early 0.10 milestones (Until M5 or M6 I think), and probably in 0.9 too, but this has been fixed (And it should work for 0.10 M7, which will be release at the end of the week).

Regards,
Camille

Previous Topic:	Import UML to Papyrus
Next Topic:	How to get all the elements from a papyrus model

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Jul 23 17:13:04 EDT 2025

.:: Contact :: Home ::.

Breadcrumbs

Sign up to our Newsletter