Skip to main content



      Home
Home » Eclipse Projects » Nebula » embedding GEF/draw2 viewer/figures in table/tree cell
embedding GEF/draw2 viewer/figures in table/tree cell [message #564599] Fri, 01 September 2006 10:03
Eclipse UserFriend
forgive the newbie question.

i have a GEF/draw2d viewer/figure that i'd like to show in a tree-table
cell. my options are

a) use Tree/TreeViewer from SWT/JFace and write owner-draw code that
will paint the figure into the appropriate cell. since there is very
little support for this use-case currently, i'll essentially have to
write everything from scratch. i'd prefer not to do this.

b) use Nebula Grid? i'm completely new to nebula and not quite sure how
to do this, or if its even a use case for the grid. if it is not
currently a use-case, is this a direction that grid will be going in. if
so, will Grid and CTableTree features be merged at some point?

c) use Nebula CTableTree which appears to have this kind of application
as an explicit use-case. i'm assuming this will be the easiest to do. my
one reservation is that i'll eventually be needing more grid-like
functionality. so if Grid is intended to support this use-case in the
near future, i'd prefer to use it instead.

guidance would be appreciated.

regards,

al
Previous Topic:[PATCH] DateTimeCellEditor
Next Topic:[PATCH] DateTimeCellEditor
Goto Forum:
  


Current Time: Sat Jul 05 20:47:52 EDT 2025

Powered by FUDForum. Page generated in 0.23257 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top