| drawing sequence diagram [message #486009] |
Tue, 15 September 2009 17:23  |
Eclipse User |
|
|
|
This must be a silly question, but after I draw in a "message" between two
"lifelines", how to I change the visible text over the message arrow?
I tried changing the "name" property of the message, but it does not
display.
My message arrows all have text more or less like: 1: *
|
|
|
|
|
|
| Re: drawing sequence diagram [message #627948 is a reply to message #486009] |
Thu, 17 September 2009 09:34  |
| Eclipse User |
|
|
|
... forwarding to UML2 Tools newsgroup.
Although I suspect this is a question specific to UML2 Tools, did you try:
- Select the message, then start typing.
- Select the message, then from the toolbar, select "All Connector Labels"
or "No Connector Labels" to hide or show all labels associated with
connectors.
Regards,
- James.
"Bruce Frazer" <bfrazer@adobe.com> wrote in message
news:98293f1e4d477181f41f59e1d4cf3f13$1@www.eclipse.org...
> This must be a silly question, but after I draw in a "message" between two
> "lifelines", how to I change the visible text over the message arrow?
>
> I tried changing the "name" property of the message, but it does not
> display.
>
> My message arrows all have text more or less like: 1: *
>
|
|
|
| Re: drawing sequence diagram [message #627951 is a reply to message #486381] |
Thu, 17 September 2009 14:42 |
| Eclipse User |
|
|
|
I tried those things - no luck. I'm pretty sure it's because my message is
between two lifelines. Looking at the OMG spec it looks like messages need
to go between actions.
But you can see from my other post that just drawing an action throws
exceptions.
|
|
|
|
Powered by
FUDForum. Page generated in 0.05707 seconds
Home