Cannot change the link line from straight line to another path. [message #484063] |
Fri, 04 September 2009 03:29  |
Eclipse User |
|
|
|
Hi all,
I have the following problem,
there is a composite figure A with compartment which contains figure B1, B2.
The connection from A to B is always straight line and cannot be modeled - it is always straight line.
The links between B1 and B2 can be modeled as I want.
What can I do to be able to change the straight line of the connection from A to B1 or B2 to have the shape I decide?
Regards,
Ivo
p.s. if it is important - the starting and ending points of these connections are fixed
|
|
|
Re: Cannot change the link line from straight line to another path. [message #484181 is a reply to message #484063] |
Fri, 04 September 2009 09:57  |
Eclipse User |
|
|
|
Ivo Petkov wrote:
> Hi all,
>
> I have the following problem,
> there is a composite figure A with compartment which contains figure B1,
> B2.
> The connection from A to B is always straight line and cannot be modeled
> - it is always straight line.
> The links between B1 and B2 can be modeled as I want.
>
> What can I do to be able to change the straight line of the connection
> from A to B1 or B2 to have the shape I decide?
>
> Regards,
> Ivo
>
> p.s. if it is important - the starting and ending points of these
> connections are fixed
By supposing you have a different connection edit part from A to B then
A to B1,B2, you could use a BendpointEditPolicy on that edit part.
--
Pascal Gélinas | Software Developer
*Nu Echo Inc.*
http://www.nuecho.com/ | http://blog.nuecho.com/
*Because performance matters.*
|
|
|
Powered by
FUDForum. Page generated in 0.05926 seconds