Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » Oomph » Running Oomph setup from the command line
Running Oomph setup from the command line [message #1814834] Thu, 19 September 2019 13:14 Go to next message
Lars Vogel - out of office until 16.03.2020 is currently offline Lars Vogel - out of office until 16.03.2020Friend
Messages: 1094
Registered: July 2009
Senior Member

Hi,

is it possible to run Oomph profiles for provisioning products and projects from the command line?

Basically, instead of starting the installer, issue a command line to create a new workspace using Oomph

Best regards, Lars
Re: Running Oomph setup from the command line [message #1814837 is a reply to message #1814834] Thu, 19 September 2019 15:43 Go to previous message
Ed Merks is currently offline Ed MerksFriend
Messages: 31158
Registered: July 2009
Senior Member
Not until someone sponsors such an effort:

https://bugs.eclipse.org/bugs/show_bug.cgi?id=487626

Mostly it could be done with the existing underlying infrastructure using a Configuration that also specifies the installation location (and the workspace location, if the Configuration as a Workspace).

https://wiki.eclipse.org/Eclipse_Oomph_Authoring#Automation_and_Specialization_with_Configurations
Previous Topic:Copyright-consistency management tool question
Next Topic:Hide empty wizard page
Goto Forum:
  


Current Time: Sat May 30 09:39:18 GMT 2020

Powered by FUDForum. Page generated in 0.01346 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top