Synchronization between xTtext editor and Sirius editor - location nodes [message #1768055] |
Thu, 13 July 2017 10:19 |
Martin Jedlicka Messages: 122 Registered: January 2016 |
Senior Member |
|
|
Hi,
I have a question for synchronization between xTtext editor and Sirius editor.
- In the xText editor, I have three nodes: Start, Operation, End. Attachment init_state.png.
- If I place a new node in the xText editor at the end (after the End node), a new node will be added to the Sirius editor at [0,0] and the other nodes will remain in the same position. Attachment add_node_after_end.png and add_node_after_end.aird
- If I place a new node in the xText editor at the end (after the End node), a new node will be added to the Sirius editor at [0,0], but all the other nodes that are behind this newly added node will also move to [0.0] - are lost arrangeConstraints KEEP_SIZE, KEEP_LOCATION a KEEP_RATIO. The same problem is when the two existing nodes are swapped or one of the existing nodes is deleted in the xText editor. Attachment add_node_before_end.png and add_node_before_end.aird
Do not you know how to avoid losing the position of existing nodes when adding a new node in the xText editor?
Thank you for your advice.
Martin
[Updated on: Thu, 13 July 2017 12:02] Report message to a moderator
|
|
|
|
Powered by
FUDForum. Page generated in 0.02330 seconds