Skip to main content



      Home
Home » Eclipse Projects » Kura » OPCUA Driver for kura 3.0.0(OPCUA Driver for kura 3.0.0)
OPCUA Driver for kura 3.0.0 [message #1763730] Fri, 19 May 2017 03:22 Go to next message
Eclipse UserFriend
HI,

I am trying kura wires. I have installed the opcua driver from eclipse marketplace. My opcua server nodeIds are in "numeric type" , is this a problem when configuring an asset ? I mean OPcUaMessages.nodeId should be a string ???
Any problem connecting with my opcua server but error reading the nodeId...

17:03:20,283 [DefaultQuartzScheduler_Worker-2] ERROR WireAsset:326 - OpcUaMessages.errorRetrievingNodeId

Any suggestion ??
Re: OPCUA Driver for kura 3.0.0 [message #1763783 is a reply to message #1763730] Fri, 19 May 2017 11:37 Go to previous messageGo to next message
Eclipse UserFriend
Hi Blanca,
could you please detail your setup?
In any case, current implementation only supports String-based node ids, so the failure with a numeric nodeId can be related to this.

Best regards,
Matteo
Re: OPCUA Driver for kura 3.0.0 [message #1771964 is a reply to message #1763783] Fri, 01 September 2017 11:33 Go to previous messageGo to next message
Eclipse UserFriend
Hi,

I have same problem but I use string for id on my opcua server, I also try with kura opcua simulator as describe on kura wire documentation but the error is still here.

Best regards,
Benjamin
Re: OPCUA Driver for kura 3.0.0 [message #1772109 is a reply to message #1771964] Tue, 05 September 2017 11:54 Go to previous message
Eclipse UserFriend
Hi Blanca and Benjamin,

You can try the Developer Preview of the next version of the OPC-UA Driver available on Eclipse Marketplace (https://marketplace.eclipse.org/content/opc-ua-driver-kura-developer-preview).
The new version adds support for more Node IDs, including numeric ones, and should hopefully also fix the reported issue.
Please keep in mind that a direct upgrade is not supported on Kura 3.0.0, before installing the new version make sure to delete any existing wire graph and remove the old deployment package.

Best regards,
Nicola
Previous Topic:Kura PWM?
Next Topic:I2C read command hangs
Goto Forum:
  


Current Time: Fri Jul 11 23:47:04 EDT 2025

Powered by FUDForum. Page generated in 0.04785 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top