Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Newcomers » Newcomers » Different GNU Tool Chain and PATH variable(Different tool chains w/ or w/o Path variable)
Different GNU Tool Chain and PATH variable [message #1759372] Tue, 11 April 2017 06:24
Robert Ty is currently offline Robert TyFriend
Messages: 17
Registered: June 2012
Junior Member
Hello,

Until now I'm using different Eclipse versions (Kepler, Mars, Neon) with
always the same old GNU ARM tool chain.

Because the old tool chain will not further be supported, I need to
switch to another newer chain. However, I would like to keep the older
Eclipse versions, the projects, as well as the old GNU ARM tool chain.

I tried it, but I run into a problem.

I think I need two PATH variables , each for one of the GNU ARM tool chains.
My problem now is, depending on the first found fitting PATH variable
( if I change the order), either the include paths of an old project now points
to the new chain or otherwise, in case of new project, the include paths
point to the old chain.

Can anybody advice how to fix this problem please?

Thank you very much.

Regards

Rob

[Updated on: Tue, 11 April 2017 06:30]

Report message to a moderator

Previous Topic:NullPointerException in SetupUIPlugin.performStartup()
Next Topic:Hello :)
Goto Forum:
  


Current Time: Thu Jun 24 13:52:42 GMT 2021

Powered by FUDForum. Page generated in 0.03477 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top