Container not related to any semantic model element [message #1392383] |
Wed, 02 July 2014 08:47 |
Benoit Ries Messages: 86 Registered: May 2013 |
Member |
|
|
Hi,
I'm currently specifying an editor for use-case diagrams. In my semantic model, I have the concepts of actors and use-cases, which I manage to display properly in my representations.
I would like to "place" all use-cases within a "System" container.
My problem is that I don't have (and I don't want) in my semantic model to have this concept.
So how can I show a container which do not have a related semantic model element. Is this even possible ?
hope I'm clear !
many thanks in advance,
Benoît
[Updated on: Wed, 02 July 2014 11:41] Report message to a moderator
|
|
|
Re: Container not related to any semantic model element [message #1392472 is a reply to message #1392383] |
Wed, 02 July 2014 11:38 |
|
Hi Benois,
You could use a container mapping based on the same semantic element
than the one used by the diagram. In this case, use “var:self” in the
semantic candidate expression.
Regards,
Florian
On 07/02/2014 10:47 AM, Benoit Ries wrote:
> Hi,
>
> I'm currently specifying an editor for use-case diagrams. In my semantic
> model, I have the concepts of actors and use-cases, which I manage to
> display properly in my representations.
>
> I would like to "place" all use-cases within a "System" container.
> My problem is that I don't have (and I don't want) in my semantic model
> to have this concept.
>
>
> So how can I show a container which do not have a related semantic model
> element. Is this even possible ?
>
>
> hope this I'm clear !
>
> many thanks in advance,
> Benoît
|
|
|
|
Powered by
FUDForum. Page generated in 0.01832 seconds