|
Re: Customize Figures and Layouts [message #209804 is a reply to message #209137] |
Wed, 29 October 2008 05:16 |
zhaozhongwei Messages: 9 Registered: July 2009 |
Junior Member |
|
|
hi, brother
here i have some opinions,one is you have only one model file,and there is
some layer ,maybe they are layouted by stacklayout,when you select
fg.a(previously other fg is selected) ,some layer move on the most up
layer,of course the layer is opaque,and the original layer is covered.
and another opinion is somewhat like html'style,actually you have three
model files when you have three tabitems.when you select fg.a(previously
other fg is selected),you call editor.setInput or other method to make the
editor change the input and refresh the view,and then you should make sure
set fg.a is selected programmatically.
maybe both of the opinions have lots of drawbacks.
i am very glad if it helps
zhao zhongwei
|
|
|
Powered by
FUDForum. Page generated in 0.03947 seconds