Kepler, Gnu ARM toolchain and OpenOCD [message #1227129] |
Fri, 03 January 2014 16:18 |
Juha Aaltonen Messages: 3 Registered: January 2014 Location: Nokia, Finland |
Junior Member |
|
|
Is there somewhere step-by-step directions how to set up the environment mentioned in the title? On 64-bit Windows 7?
My aim is using Eclipse for development for STM3240-EVAL board.
I've tried this and that, but I seem to have problems with GDB-OpenOCD communication.
OpenOCD can connect to my board (via ST-Linkv2), and connection from GDB to OpenOCD is established, but quite soon dropped: Ack without pending data.
Also, is Zylin? Should I install Zylin to replace GDB (arm-none-eabi-gdb.exe)?
Can the pipe be used easier then instead of network interface?
I put these questions here, because I don't know any better suitable forums.
|
|
|
Powered by
FUDForum. Page generated in 0.02889 seconds