Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » Papyrus » UML model to SysML model(Change/migrate model with state machines from UML to SysML model)
UML model to SysML model [message #1153503] Thu, 24 October 2013 17:02 Go to next message
Rupert Schlick is currently offline Rupert SchlickFriend
Messages: 9
Registered: November 2009
Junior Member
Is there an easy way to migrate a model that was started as an Papyrus UML model into a SysML model?

We have models with complex state machines as UML models. Now, these models shall be extended with requirements information, which would work best in a SysML requirements diagram/table.

I'm thankful for any hints.

Regards

Rupert

Report message to a moderator

Re: UML model to SysML model [message #1153510 is a reply to message #1153503] Thu, 24 October 2013 17:10 Go to previous messageGo to next message
Camille Letavernier is currently offline Camille LetavernierFriend
Messages: 952
Registered: February 2011
Senior Member
Hi Rupert,

Simply apply the SysML Profile to your model. After that, you will be able to create pure SysML Diagrams/Tables (e.g. Requirement diagram/table). You will also be able to create standard UML diagrams (With or without SysML elements).

Regards,
Camille

Camille Letavernier

Report message to a moderator

Re: UML model to SysML model [message #1153528 is a reply to message #1153510] Thu, 24 October 2013 17:24 Go to previous messageGo to next message
Rupert Schlick is currently offline Rupert SchlickFriend
Messages: 9
Registered: November 2009
Junior Member
Hi Camille,

thanks for the help.

Dumb mistake on my side - I tried what you suggested before asking, but only applied the SysML::Requirements profile, not the SysML base profile.

best
Rupert

Report message to a moderator

Re: UML model to SysML model [message #1844901 is a reply to message #1153503] Wed, 29 September 2021 10:06 Go to previous message
Erik Stringwell is currently offline Erik StringwellFriend
Messages: 8
Registered: January 2021
Junior Member
The only maybe not so obvious thing that you would also need to do is "Switch Architecture Context...". Otherwise you are stuck with the Palette and diagram types from the UML Architecture Context.

Report message to a moderator

Previous Topic:Fail - papyrus-robotics-2021-03 #726
Next Topic:Papyrus Software Designer 5.2 Documentation gone?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Tue Apr 23 13:28:40 GMT 2024

Powered by FUDForum. Page generated in 0.03817 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top

Sign up to our Newsletter

A fresh new issue delivered monthly