WSDL Editor - unable to set type for a custom type element [message #166689] |
Thu, 13 April 2006 07:12 |
Eclipse User |
|
|
|
Originally posted by: na.na.com
Hi,
I have created a WSDL file for a service I am writing in perl. After
creating a new complex type, adding a sequence and then a few elements
I am unable to alter the type for any of those elements.
I have tried following the tutorial for the WSDL editor and there is a
dialogue box that is shown that I am unable to find. There is a
button next to the type description that has three dots inside which I
assume would enable you to make a selection (using the dialogue) but
this does not do anything.
I can edit the WSDL directly to alter the type of these elements which
is successful and shown on the interface.
I am using R-1.0.2RC1-200604070459 and Eclipse 3.1.2.
Any help would be appreciated.
Cheers,
Tom
|
|
|
Re: WSDL Editor - unable to set type for a custom type element [message #166696 is a reply to message #166689] |
Thu, 13 April 2006 08:50 |
Eclipse User |
|
|
|
Originally posted by: na.na.com
All sorted, it was me being stupid which is usually the case.
I had not correctly defined my namespaces.
Cheers,
Tom
On Thu, 13 Apr 2006 08:12:02 +0100, Tom <na@na.com> wrote:
>Hi,
>
>I have created a WSDL file for a service I am writing in perl. After
>creating a new complex type, adding a sequence and then a few elements
>I am unable to alter the type for any of those elements.
>
>I have tried following the tutorial for the WSDL editor and there is a
>dialogue box that is shown that I am unable to find. There is a
>button next to the type description that has three dots inside which I
>assume would enable you to make a selection (using the dialogue) but
>this does not do anything.
>
>I can edit the WSDL directly to alter the type of these elements which
>is successful and shown on the interface.
>
>I am using R-1.0.2RC1-200604070459 and Eclipse 3.1.2.
>
>Any help would be appreciated.
>
>Cheers,
>Tom
|
|
|
Powered by
FUDForum. Page generated in 0.48946 seconds