Visualize connections when Source and Target(EditParts) are the same. [message #162065] |
Sat, 18 December 2004 13:23 |
Eclipse User |
|
|
|
Originally posted by: alimail.onlinehome.de
Hello everybody,
I want to visualize a state diagram with gef. When nodes are states and
connections are (state-)transitions there is exists also
"self"-Transitions, a connection where source a target node is the same.
My standard visualization (polyLine with Arrow-Decoration) paints
only an arrow at the bottom of the node-figure. But i want to visualize
it like this:
node<--
| |
| |
-------
my hope is that someone has already coded somethign similar like this
above... Any suggestions?
Alex
|
|
|
|
Re: Visualize connections when Source and Target(EditParts) are the same. [message #162572 is a reply to message #162065] |
Wed, 22 December 2004 15:42 |
Eclipse User |
|
|
|
Originally posted by: none.us.ibm.com
You need to identify this special case in your connection router, and create
the loopback points.
"alitari" <alimail@onlinehome.de> wrote in message
news:cq1b4s$5m5$1@www.eclipse.org...
> Hello everybody,
>
> I want to visualize a state diagram with gef. When nodes are states and
> connections are (state-)transitions there is exists also
> "self"-Transitions, a connection where source a target node is the same.
> My standard visualization (polyLine with Arrow-Decoration) paints
> only an arrow at the bottom of the node-figure. But i want to visualize
> it like this:
>
> node<--
> | |
> | |
> -------
> my hope is that someone has already coded somethign similar like this
> above... Any suggestions?
>
> Alex
|
|
|
|
Powered by
FUDForum. Page generated in 0.03443 seconds