|
|
| Re: DurationConstraints and Oberservations do not work in Kepler M6 release [message #1042233 is a reply to message #1041515] |
Tue, 16 April 2013 06:36  |
 Marc-Florian Wendland
Messages: 83
Registered: January 2013 |
Member |
|
|
Hi Camille,
somthing must have changed.
In 0.9.2 creation of these Time-related constraint was straight forward and
stable, in 0.10.0 nightly, it is very inconvient since the little circles
that indicate the MessageOccurrenceSpecification are not aligned with the
visual message end but somewhere above or below. So, it is in general
possible to establish these constraints and if you have found the
corresponding MessageOccurrenceSpecification of Message, the visual
Constraint is aligned correctly. But as I said, it is very inconvient to
look for these MessageOccurrenceSpecification (that should be at the same
location where the Message end/start hits the Lifeline).
I filed a bug (https://bugs.eclipse.org/bugs/show_bug.cgi?id=405762).
Regards,
Marc-Florian
"Camille Letavernier" wrote in message news:kkganl$id$1@xxxxxxxxe.org...
Hi Marc-Florian,
The Sequence Diagram was maintained on the 0.9.X branch only, until a few
days after M6. It should work properly on the Kepler nightly builds,
however.
So, if something doesn't work properly on Kepler Nightly, you can fill a bug
Thank you,
Camille
|
|
|
Powered by
FUDForum. Page generated in 0.51940 seconds
] 
Search
Help
Register
Login
Home
