Eclipse Community Forums: BIRT » Graphic series interrvals

Help

Home

Home » Archived » BIRT » Graphic series interrvals

Show: Today's Messages :: Show Polls :: Message Navigator

Graphic series interrvals [message #1014374]

Mon, 25 February 2013 17:26

Mimmo Rossi

Messages: 146
Registered: February 2013

Senior Member

Hi,
i seen that there is a possibility to set step of a series, but there is a possibility to set intervals?
That is to say, i would have this:
series 1= 0 - 2 - 4 - 6 - 8
series 2= 0.2 - 3.6 - 3.9 - 5.7 - 8

that is to say i would have two equal intervals of 5 elements.

Thanks in advance

Report message to a moderator

Re: Graphic series interrvals [message #1014401 is a reply to message #1014374]

Mon, 25 February 2013 18:50

Michael Williams

Messages: 1925
Registered: July 2009

Senior Member

I'm not sure I'm completely understanding. Could you explain this in a little more detail?

Michael

Developer Evangelist, Silanis

Report message to a moderator

Re: Graphic series interrvals [message #1014798 is a reply to message #1014401]

Tue, 26 February 2013 13:36

Mimmo Rossi

Messages: 146
Registered: February 2013

Senior Member

In this chart:

https://dl.dropbox.com/u/47586998/img.JPG

the series on the left has a series with 6 values, i would that also the series on the right has 6 values.
Thanks

Report message to a moderator

Re: Graphic series interrvals [message #1014909 is a reply to message #1014798]

Tue, 26 February 2013 18:13

Michael Williams

Messages: 1925
Registered: July 2009

Senior Member

Are the ranges going to be dynamic or static?

Michael

Developer Evangelist, Silanis

Report message to a moderator

Re: Graphic series interrvals [message #1015040 is a reply to message #1014909]

Wed, 27 February 2013 09:29

Mimmo Rossi

Messages: 146
Registered: February 2013

Senior Member

I would that the series 2 have the same intervals of series 1, so dynamic is better, but also static might be ok.

Report message to a moderator

Re: Graphic series interrvals [message #1015288 is a reply to message #1015040]

Thu, 28 February 2013 04:17

Michael Williams

Messages: 1925
Registered: July 2009

Senior Member

If your values will always be in a particular range, for both series, you'd be able to set these intervals within the chart editor. If the values will be dynamic, for example the first series can be more than 6 or the second series can be less than 3.9 or greater than 4.8. I think based off your original post, this is the case. What you'd need to do here, is use the afterDataSetFilled script to find the min and max values for each series. Then, in the beforeGeneration, set the axis min, max, and step.

Michael

Developer Evangelist, Silanis

Report message to a moderator