Update sites behind proxy with Kepler M4 [message #1007497] |
Wed, 06 February 2013 08:20 |
Jean Rebillat Messages: 14 Registered: December 2010 |
Junior Member |
|
|
Hi.
I am using a proxy to access Internet. Thus, to have access to the Eclipse update sites, I have to go through the proxy.
With Juno (and Juno SR1) I had nothing to do, the system settings were taken into account. Accessing update sites was not a problem.
I wanted to switch to Kepler M4, but it seems that the proxy settings do not work anymore : I can't access to the update sites.
To be more precise, I did the following test:
1- Download any Juno package, unpack it, launch it on a new empty workspace, don't do anything but use menu to go to "Install new software" and request the list from any already known update site : you get the list.
2- Do the same with Kepler (M4 or M5, I did not test earlier milestones), you will not get the list (blocked at 2%).
Is there a way to get around this problem ?
|
|
|
Powered by
FUDForum. Page generated in 0.08269 seconds