|
|
Re: diagram palette [message #997262 is a reply to message #997172] |
Fri, 04 January 2013 19:24 |
joe fessler Messages: 4 Registered: December 2012 |
Junior Member |
|
|
Same story with a new workspace.
Now, an observation (but not a pleasant one):
In this new workspace, right-click->New->Other->Papyrus->Papyrus Project follows through the usual wizard. If a project is created by naming the project and clicking Finish, subsequent opening of the model.dl produces an empty tab panel.
If, instead, the Next button is clicked, progressing through selection of the diagram language (UML), checking UML Class Diagram (e.g.) and THEN Finish, the New Papyrus Project dialog remains active and a second click of Finish closes the procedure. The result here though produces a tab panel with no label. Closing that tab and attempting to reopen the model.dl throws a NullPointerException.
At no time does a palette show.
The observation above also applies to the old workspace, so at least that much is consistent.
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.03085 seconds