|Re: Switch between outlines [message #902010 is a reply to message #901939]
||Wed, 15 August 2012 13:29
| Bertin Kiekebosch
Registered: August 2011
I tested your example and it works fine, but this part works OK for my own project too.
The problem in my own project is that in the outline that is shown after the switch, the tablePages will not show up anymore.
When I start my application the first (BugsOutline) outline is shown and next to that, the first tablePage (BugsAndFeaturesTablePage) is shown.
If I then switch to another outline, the tablePage in the second outline is gone, and if I switch back to the first outline then there the tablePage is also gone.
I have my desktop and outlines files attached.
Powered by FUDForum
. Page generated in 0.02482 seconds