Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » General (non-technical) » Project Proposals » Toolchain Editor?(User Defined Toolchain)
Toolchain Editor? [message #868906] Wed, 02 May 2012 18:06 Go to next message
Matthew Jeschke is currently offline Matthew JeschkeFriend
Messages: 1
Registered: May 2012
Junior Member
Please forgive me I'm new to this forum and after reading all the categories was still unsure where to post this question.

I've used eclipse off and on for the past 10 years. However, it always seems to be a bit confusing to me how to add a self defined toolchain.

I'm working a lot with ARM and PIC micro-controllers. I'd like to be able to setup toolchain definitions for those projects. Then be able to select the toolchains I previously defined when I build projects for these microcontrollers.

I'm looking at the toolchain editor under project->preferences. However, I cannot figure out for the life of me how to setup a new toolchain (eg ARM, or pic) and point it to the tools that build the project.

Can somebody please point me in the right direction. I've been googling and searching the forum for a solution for a few days now.

Thanks!


Re: Toolchain Editor? [message #868948 is a reply to message #868906] Wed, 02 May 2012 19:10 Go to previous message
Wayne Beaton is currently offline Wayne BeatonFriend
Messages: 554
Registered: December 2017
Senior Member
I think that you might be able to get help from the CDT project.

http://www.eclipse.org/forums/eclipse.cdt

HTH,

Wayne

On 05/02/2012 02:07 PM, Matthew Jeschke wrote:
> Please forgive me I'm new to this forum and after reading all the
> categories was still unsure where to post this question.
>
> I've used eclipse off and on for the past 10 years. However, it always
> seems to be a bit confusing to me how to add a self defined toolchain.
>
> I'm working a lot with ARM and PIC micro-controllers. I'd like to be
> able to setup toolchain definitions for those projects. Then be able to
> select the toolchains I previously defined when I build projects for
> these microcontrollers.
>
> I'm looking at the toolchain editor under project->preferences.
> However, I cannot figure out for the life of me how to setup a new
> toolchain (eg ARM, or pic) and point it to the tools that build the
> project.
>
> Can somebody please point me in the right direction. I've been googling
> and searching the forum for a solution for a few days now.
>
> Thanks!
>
>
>
Previous Topic:Plugin to remote-Backup eclipse-settings
Next Topic:Use captcha instead of minimum postcount for spam-protection
Goto Forum:
  


Current Time: Tue Mar 19 05:59:35 GMT 2024

Powered by FUDForum. Page generated in 0.03259 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top