Eclipse Community Forums: Hudson » Initial Installation Enable Security Problem

Help

Home

Home » Archived » Hudson » Initial Installation Enable Security Problem

Show: Today's Messages :: Show Polls :: Message Navigator

Initial Installation Enable Security Problem [message #864012]

Sun, 29 April 2012 19:44

Ian Selfe

Messages: 2
Registered: April 2012

Junior Member

After installing Hudson 2.2 using Tomcat 6.0.35 I am able to access the UI successfully. I am trying to secure Hudson using the Standard Security Setup page in the current documentation. ( unable to link because I haven't posted more than 25 messages )

When i try to log in as the first user, I am taken to a HTTP 404 page.

I have disabled security by editing my config.xml and ran through the steps for Standard Security Setup again, yet I still run into the 404 when I try to log in.

Any suggestions? Has anybody ran into this problem before?

Report message to a moderator

Re: Initial Installation Enable Security Problem [message #867923 is a reply to message #864012]

Tue, 01 May 2012 14:57

Winston Prakash

Messages: 534
Registered: August 2011
Location: Fremont, CA USA

Senior Member

What Authentication and authorization you setup? Did you remove both
authorization and Authentication elements in the config.xml file.

Did you look at the Tomcat log file to see what kind of exception is
reported?

- Winston

On 4/29/12 12:44 PM, Ian Selfe wrote:
> After installing Hudson 2.2 using Tomcat 6.0.35 I am able to access the
> UI successfully. I am trying to secure Hudson using the Standard
> Security Setup page in the current documentation. ( unable to link
> because I haven't posted more than 25 messages )
> When i try to log in as the first user, I am taken to a HTTP 404 page.
> I have disabled security by editing my config.xml and ran through the
> steps for Standard Security Setup again, yet I still run into the 404
> when I try to log in.
>
> Any suggestions? Has anybody ran into this problem before?

Winston Prakash
Eclipse Hudson team

Report message to a moderator

Re: Initial Installation Enable Security Problem [message #867977 is a reply to message #867923]

Tue, 01 May 2012 15:26

Ian Selfe

Messages: 2
Registered: April 2012

Junior Member

I used
- Hudson's own user database
- Matrix-based security

I allowed anon to read all then created a user "setup" as the first user. I then created that user and attempted to login.
Unfortunately, the Virtual Machine I installed on has been wiped away since the issue, so I don't have access to the Tomcat logs. I'm going to set Hudson up later this afternoon on a new machine.

Report message to a moderator

Previous Topic:	Deploy Artifacts Checkbox
Next Topic:	Debugging Subversion plugin

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat Apr 20 02:05:37 GMT 2024

.:: Contact :: Home ::.

Breadcrumbs

Sign up to our Newsletter