Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Archived » AMP » AMP contains non IP-approved content?!
AMP contains non IP-approved content?! [message #764147] Sun, 11 December 2011 13:52 Go to next message
Werner Keil is currently offline Werner KeilFriend
Messages: 1087
Registered: July 2009
Senior Member
Hi,

Just installed the Modeling distro of Indigo SR1 after DemoCamp attendees
including Eike Stepper suggested, we might follow up on earlier discussed
UOMo/UCUM integration with EMF. When looking up Modeling Components, the
discovery tool states, AMP contains non IP-approved content.

How did you even get it into the discovery then?!;-|

Thanks,
Werner
Re: AMP contains non IP-approved content?! [message #764732 is a reply to message #764147] Mon, 12 December 2011 19:05 Go to previous message
Miles Parker is currently offline Miles ParkerFriend
Messages: 1341
Registered: July 2009
Senior Member
Quote:
When looking up Modeling Components, the
discovery tool states, AMP contains non IP-approved content.

How did you even get it into the discovery then?!;-|


IIRC, this was actually one of the original reasons for the Discovery setup. Xtext also had such non Eclipse-IP pieces for their ANTLR integration. This is essentially the same approach that SVN uses for their non-Eclipse connectors. But we went through it pretty carefully to make sure that the notifications were there.

You can also just get the features from the AMP feature site. The only non-Eclipse IP stuff is the support for 3D graphics which is completely an optional thing.
Previous Topic:Communication between agents through messages
Next Topic:Agent having dynamic structures
Goto Forum:
  


Current Time: Tue Oct 08 19:15:41 GMT 2024

Powered by FUDForum. Page generated in 0.04632 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top