Eclipse Community Forums: AMP » AMP contains non IP-approved content?!

Help

Home

Home » Archived » AMP » AMP contains non IP-approved content?!

Show: Today's Messages :: Show Polls :: Message Navigator

AMP contains non IP-approved content?! [message #764147]

Sun, 11 December 2011 13:52

Werner Keil

Messages: 1087
Registered: July 2009

Senior Member

Hi,

Just installed the Modeling distro of Indigo SR1 after DemoCamp attendees
including Eike Stepper suggested, we might follow up on earlier discussed
UOMo/UCUM integration with EMF. When looking up Modeling Components, the
discovery tool states, AMP contains non IP-approved content.

How did you even get it into the discovery then?!;-|

Thanks,
Werner

Report message to a moderator

Re: AMP contains non IP-approved content?! [message #764732 is a reply to message #764147]

Mon, 12 December 2011 19:05

Miles Parker

Messages: 1341
Registered: July 2009

Senior Member

Quote:

When looking up Modeling Components, the
discovery tool states, AMP contains non IP-approved content.

How did you even get it into the discovery then?!;-|

IIRC, this was actually one of the original reasons for the Discovery setup. Xtext also had such non Eclipse-IP pieces for their ANTLR integration. This is essentially the same approach that SVN uses for their non-Eclipse connectors. But we went through it pretty carefully to make sure that the notifications were there.

You can also just get the features from the AMP feature site. The only non-Eclipse IP stuff is the support for 3D graphics which is completely an optional thing.

Report message to a moderator

Previous Topic:	Communication between agents through messages
Next Topic:	Agent having dynamic structures

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Mon Dec 04 22:47:59 GMT 2023

.:: Contact :: Home ::.

Breadcrumbs

Sign up to our Newsletter