Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Archived » Jubula » Object Mapping Mode on the toolbar is inactive.
Object Mapping Mode on the toolbar is inactive. [message #749939] Tue, 25 October 2011 14:29 Go to next message
hft_10  is currently offline hft_10 Friend
Messages: 8
Registered: October 2011
Junior Member
Hi,

I have a problem in object mapping.

Object mapping mode on the toolbar is always inactive.
I tried the same thing with the object mapping editor. The editor can be opened,but object mapping is not possible. The logical component names are complete, but no technical component names.

Actually,I done all the steps in chapter 3.15.1 Object mapping from User Manual

Jubula can connected to the AUT Agent and started AUT.
GUI is running, but it is not with a green border.

Thanks for any help.

Re: Object Mapping Mode on the toolbar is inactive. [message #749957 is a reply to message #749939] Tue, 25 October 2011 14:40 Go to previous messageGo to next message
Oliver Goetz is currently offline Oliver GoetzFriend
Messages: 219
Registered: May 2011
Senior Member
Hi,

Are you sure that the AUT is running? (Can you see it in the "Running AUTs View"?). The most likely cause of the toolbar being disabled for Object Mapping would be that no AUT is started (or if one is, that it is not correctly registered to the agent as being successfully started). If your AUT is a RCP AUT be sure that the RCP remote control plugin is installed correctly (http://help.eclipse.org/indigo/topic/org.eclipse.jubula.client.ua.help/html/manual/node282.html). If you have more than one AUT running be sure you´re connected with the right AUT you want to use for object mapping.
Regards
Oliver
Re: Object Mapping Mode on the toolbar is inactive. [message #752769 is a reply to message #749957] Wed, 26 October 2011 14:09 Go to previous message
hft_10  is currently offline hft_10 Friend
Messages: 8
Registered: October 2011
Junior Member
Hi Oliver,

Thanks for the answer.

Now it is clear. The Problem was due to the code of AUT.

So,the RCP remote control plugin for component recognition is not yet loaded when the splash screen appears.

thanks again.
Previous Topic:Upcoming training course at BREDEX
Next Topic:Preparing for the Jubula Tutorial at Eclipse Con Europe
Goto Forum:
  


Current Time: Thu Mar 28 21:27:51 GMT 2024

Powered by FUDForum. Page generated in 0.02733 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top