Eclipse Community Forums: ServerTools (WTP) » WSDL Validation errors don't show up on XML Spy

Home » Language IDEs » ServerTools (WTP) » WSDL Validation errors don't show up on XML Spy(Errors shown in Eclipse using WST don't show up in XML Spy)

Show: Today's Messages :: Show Polls :: Message Navigator

WSDL Validation errors don't show up on XML Spy [message #656159]

Thu, 24 February 2011 11:30

Ravikanth Somayaji

Messages: 49
Registered: July 2009
Location: Oxford

Member

When I validate a WSDL in the Eclipse WST WSDL editor it shows up the following errors -

cvc-complex-type.2.4.a: Invalid content was found starting with element 'wsdl:fault'

cvc-minLength-valid: Value '' with length = '0' is not facet-valid with respect to minLength '1' for type 'NMTOKENS'.

cvc-attribute.3: The value '' of attribute 'parts' on element 'soap:body' is not valid with respect to its type, 'NMTOKENS'.

But the same errors don't show up in XML Spy.

Is it that the WST WSDL Validate is doing the wrong thing, or that XML Spy validations are very relaxed??

Report message to a moderator

Re: WSDL Validation errors don't show up on XML Spy [message #656220 is a reply to message #656159]

Thu, 24 February 2011 15:43

Atosa Khoddamhazrati

Messages: 3
Registered: November 2010

Junior Member

Are you using the Professional Edition or Enterprise Edition. There are differences in the level of validation for each.

Please refer to thislink for more information:
http://manual.altova.com/XMLSpy/spyenterprise/index.html?val idatingwsdl.htm

Hope this helps.

Report message to a moderator