|
|
|
|
Re: Pespective entry in Application.e4xmi [message #654262 is a reply to message #654198] |
Mon, 14 February 2011 19:43 |
Holger Sachse Messages: 12 Registered: February 2011 Location: Hamburg |
Junior Member |
|
|
Paul,
checked your references and still not getting the result I am talking about.
I took the photo demo and added in the application model under label "Photo P1" for the perspective entry. I left the demo with one perspective only, so no need to switch anything. If I run the demo I would expect that this label content shows up in a tab folder like representation (like in the e4 IDE there on the right side) or in any other one.
But I do not see anything.
I took also the perspective switch handler example and build it in my training application. It works exchanging the perspectives but leaving no information (see the reference to the perspective tab folders) about the other open perspectives. Is this what you mean with the reference to the IBM code?
Holger
P.S. Can somebody give me the rigths to make attachements to add examples?!
[Updated on: Mon, 14 February 2011 19:50] Report message to a moderator
|
|
|
|
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.04802 seconds