Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » Papyrus » 3. Can not connect ports on Internal Block Diagrams - bug?
3. Can not connect ports on Internal Block Diagrams - bug? [message #646378] Thu, 23 December 2010 15:13
Ernest  is currently offline Ernest Friend
Messages: 1
Registered: December 2010
Junior Member
It is impossible to connect two ports belonging to different blocks. Simple scenario:

a. Place two blocks on a diagram select "Block" element from Nodes explorer and place it on canvas. Do this two times.
b. Place FlowPort (OUT) on the first block and FlowPort (IN) on the second block.
c. Try to connect those ports using "Connector" element from Edges explorer.
d. In my case it is impossible to connect them. The same happens with any other combination of two ports: FlowPort (IN) with FlowPort (IN), Port with Port, etc.
Previous Topic:Racional Rose to Papyrus
Next Topic:emf validation constraints status
Goto Forum:
  


Current Time: Sun Aug 09 15:21:50 GMT 2020

Powered by FUDForum. Page generated in 0.02342 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top