|
Re: Scripted Data Set Parameters dont work in Designer 2.6.1 [message #641232 is a reply to message #641086] |
Wed, 24 November 2010 15:29 |
|
Mark,
This sounds like a bug. Can you open a bugzilla entry for it?
Jason
On 11/24/2010 3:55 AM, Mark Mescher wrote:
> Hi out there,
> I have a problem with the designer (2.6.1) when using scripted Data Sets
> (Java based event handler). Just try the following:
> Create a new Sripted Data Set and add some Output Columns and a
> Parameter. Save your report. Now add one more parameter and save again
> -> everything should work till now. Now switch to the advanced
> properties tab of the dataset and add an event handler (must not be a
> real event handler, can be something like "test"). Save your report.
> Now add one more parameter to your dataset and leave the dialog. Try to
> save, it will not work. Save is disabled and will never be enabled again
> until you close and open the report again.
> Solution: Open your report, make some change e.g. to a table (save
> button will be enabled) and add the parameter after this. Than you can
> save your report.
> Does anyone know a solution / fix for this? Will I have to make some
> changes to my scipted Data Set or is it a bug?
>
> Thanks a lot
>
> Mark
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.03190 seconds