Cascading Parameters - default values [message #640098] |
Fri, 19 November 2010 05:37 |
Josh Hall Messages: 31 Registered: October 2010 |
Member |
|
|
Hi,
I have a Cascading Parameter Group set up. The top level Parameter is for 'Organisation Type' and it feeds the second level Parameter of 'Organisations'. Each has a default value of 'All'. When I run the report, the two parameters drop-downs default to 'All' as expected. I then select an 'Organisation Type' and the 'Organisation' list filters to the relevant entries - again, as expected. I then re-select 'All' in 'Organisation Type' and the only item in Organisation is a blank option. What I would like to happen here is that Organisation also reverts to it's default value of 'All'. I can't figure out how to make it do this. Any ideas?
Thanks & Regards,
Josh.
|
|
|
Powered by
FUDForum. Page generated in 0.02408 seconds