Creating EMap using MagicDraw [message #627854] |
Thu, 06 August 2009 13:47 |
hussain M Messages: 2 Registered: August 2009 |
Junior Member |
|
|
Hello Everybody,
I am using MagicDraw tool for creating class diagrams.
Using the Export option in Magicdraw i am exporting my class diagram as
EMF-xmi i.e having an extension of uml.
I am importing this uml in my eclipse and creating an ECore and genmodel
out of this.
So i am using the same class diagram to create an Ecore out of it.
Fore creation of a Map in ECore, i can directly edit ecore for creating
ecore in the steps followed in the below link:
http://wiki.eclipse.org/EMF/FAQ#How_do_I_create_a_Map_in_EMF .3F
But is there any way that in class diagram only , i can set some
properties so that Map is obtained in the generated ecore file.
Thanks in Advance!!
Regards,
Zaks
|
|
|
Powered by
FUDForum. Page generated in 0.02936 seconds