|Re: selection in ecore editor reverting to previous node [message #627884 is a reply to message #627094]
||Thu, 23 September 2010 06:23
| Ed Merks
Registered: July 2009
Invoking a command generally updates the selection to be the object
affected by the command. E.g., when you create a child, the child is
selected. So while what you describe might be a little annoying, it is
expected. If you complete the cell editing (e.g., with an enter) before
you select, you'll get different behavior.
Jay Norwood wrote:
> I've noticed a selection issue that involves interaction between
> property sheet and the emf generated editor, which can be
> demonstrated in the ecore editor.
> 1. Modify a field in your property sheet.
> 2. Without changing focus from the property sheet field, select a new
> node in the ecore editor.
> What I'd expect to happen is something similar to what happens when
> you select a new field in the property sheet, which is the original
> field completes the assignment, and the selection stays on the new cell.
> What happens if you select a field in the editor (moving from the
> property sheet) is that the original field in the property sheet
> completes its assignment, but the selection in the editor page jumps
> back to the original node.
Powered by FUDForum
. Page generated in 0.01632 seconds