Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » UML2 » EMF.edit commands
EMF.edit commands [message #622843] Fri, 06 July 2007 02:48
Bogdan Pistol is currently offline Bogdan PistolFriend
Messages: 29
Registered: July 2009
Junior Member

I have a few things not very clear about the edit commands.

I'm using an AdapterFactoryEditingDomain with commands in a
BasicCommandStack. I tested successfully the ChangeCommand (it modifies the
model and undo/redo works).

Is there a reason I should use SetCommand, or AddCommand or other commands?
I could make the same "set" and "add" with model changes inside a ChangeCommand.
What is the difference between the two approaches?


Bogdan Pistol,
Previous Topic:EMF.edit commands usage
Next Topic:Problem with navigable owned end
Goto Forum:

Current Time: Fri Jun 05 20:00:57 GMT 2020

Powered by FUDForum. Page generated in 0.01885 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top