Skip to main content

Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » EMF "Technology" (Ecore Tools, EMFatic, etc)  » emf model importer: prefix names are always "type"
emf model importer: prefix names are always "type" [message #602092] Fri, 02 February 2007 22:58
Brian Vetter is currently offline Brian VetterFriend
Messages: 74
Registered: July 2009
When I use the emf model importer to pull in an XSD into an ecore model, the name prefix placed in the ecore model for all of the referenced/imported types are the same: "types". While it doesn't seem to bother the emf internals too much, it causes much grief when I use Teneo to map these types to database tables. The prefix names are used to scope the table names.

I think the proper behavior would be to use the prefix names as defined in the XSDs (either the including XSDs or perhaps the ones where the types are actually created). Is this a reasonable request or is there something that keeps this from working this way?

I can work around this temporarily by doing this by hand for now, but ultimately, I need to do this completely programmatically.

Previous Topic:Teneo: Identity (ID) scope conflicts
Next Topic:emf model importer: prefix names are always "type"
Goto Forum:

Current Time: Wed Apr 21 06:01:47 GMT 2021

Powered by FUDForum. Page generated in 0.01973 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top